Skip to content
Qanoon Digest

This SRO amends the S.R.O. 565(I)/2006, dated the 5th June, 2006

SRO 676(I)/2007 is a Customs SRO dated 4 July 2007, listed by FBR as "This SRO amends the S.R.O. 565(I)/2006, dated the 5th June, 2006".

The text below was extracted automatically from the text layer of the official PDF. Line breaks and table layout may differ from the original, and where FBR scanned the paper and added a machine-read text layer, that layer can contain misread characters. Check the official PDF before relying on any wording or figure.

Page 1

GOVERNMENT OF PAKISTAN MINISTRY OF FINANCE, ECONOMIC AFFAIRS, STATISTICS AND REVENUE (REVENUE DIVISION) ***** Islamabad, the 4th July, 2007. NOTIFICATION (CUSTOMS) S.R.O.676(I)/2007.- In exercise of the powers conferred by section 19 of the Customs Act, 1969 (IV of 1969), the Federal Government is pleased to direct that the following further amendments shall be made in its Notification No. S.R.O. 565(I)/2006, dated the 5th June, 2006 and shall be deemed to have been so made on 10th June, 2007, namely: - In the aforesaid Notification, in the Table, in column (1), - (1) S. No. 1 and corresponding entries relating thereto in columns (2), (3), (4), (5) and (6) shall be omitted; (2) against S. No. 2,- (i) under heading “raw materials” in column (3), in entry (4) after the word “sheet” the words “in coils” shall be inserted; and (ii) in column (3), under heading Sub-components and Components against entry (6), in column (4), for the figure “8501.4099” the figure “8501.4090” shall be substituted; (3) against S. No. 3, in column (3), under heading Sub-components and Components against entry (5), in column (4), for the figure “8501.4099” the figure “8501.4090” shall be substituted; (4) against S. No. 4, in column (3), under heading Sub-components and Components,- (i) against entry (4), in column (4), for the figure “8501.4099” the figure “8501.4090” shall be substituted; and (ii) for entry (6) and entries relating thereto in columns (4) and (5), the following shall be substituted, namely; “(6) Glass Door for use in 8418.9990 10% ad val. Visicoolers (6A) Compressor. 8414.3010 0% ad val.”;

Page 2

(5) against S. No. 5, in column (3) under heading Sub-components and Components, against entry (2), in column (4), for the figure “8501.4099” the figure “8501.4090” shall be substituted; (6) against S. No. 6, in column (3) under heading Sub-components and Components, (i) against entries (7), (8), (9), and (10), in column (4), for the figure “8415.9090” the figure “8415.9091” shall respectively be substituted; (ii) against entries (12), (13), (14), (15), (16), (17), (18), (19) and (20), in column (4), for the figure “8415.9099” the figure “8415.9091” shall respectively be substituted; (iii) against entries (22) and (23), in column (4), for the figure “8415.9090” the figure “8415.9091” shall respectively be substituted; and (iv) against entries (28) and (29), in column (4), for the figure “8415.9099” the figure “8415.9091” shall respectively be substituted; (7) against S. No. (8), in column (3), entry (1) and corresponding entry relating thereto in column (4) shall be omitted; (8) against S. No. (9), in column (3), entry (10) and corresponding entry relating thereto in column (4) shall be omitted; (9) against S. No. (20), in column (3), entries (32) and (33) and corresponding entries relating thereto in column (4) shall be omitted; (10) against S. No. 22,- (i) in column (5), for the figure “5” the figure “0” shall be substituted; (ii) in column (3), entry (4) and corresponding entry relating thereto in column (4) shall be omitted; and (iii) after entry (5) in columns (3), the following new entries and corresponding entries relating thereto in columns (3) and (4), shall be added, namely,- “(6) Prepared Binder 3824.9030 (7) Printed Emulsion 3824.9099”; (11) against S. No. 24,- (i) in column (3), entries (8), (9), (10), (15), (17) and (19) and corresponding entries relating thereto in column (4) shall be omitted; and (ii) against entry (25) in column (3), in column (4), for the figure “8525.1090” the figure “8525.5090” shall be substituted; (12) against S. No. 25, against entry (8) in column (3), in column (4), for the figure

Page 3

“8536.4900” the figure “8536.5099” shall be substituted; (13) against S. No. 28, in column (4), for the figure “8471.6079” the words “Respective Headings” shall be substituted; (14) against S. No. 29, against entry (1) in column (3), in column (4), for the figure “7208.0000” the figures “7208.5190”, “7208.5290”, “7208.5390” and “7208.5490”, shall be substituted; (15) against S. No. 33,- (i) in column (3), after the word “heading” the figure and the comma “85.17,” shall be inserted; and (ii) in column (4), for the figure “8529.9090” the figure “8517.7000” shall be substituted; (16) against S. No. 34,- (i) under heading (A) in column (3),- (a) entry (1) and corresponding entry relating thereto in column (4) shall be omitted; (b) against entry (3), in column (4), for the figure “3904.1090” the figure “3904.2200” shall be substituted; and (c) entry (7) and corresponding entry relating thereto in column (4) shall be omitted; (ii) under heading (C) in column (3), entries (2) and (4) and corresponding entries relating thereto in column (4) shall be omitted; (17) in S. No. 36,- (i) in column (3), entries (1), (2) and (4) and corresponding entries relating thereto in column (4) shall be omitted; and (ii) against entries (10), (11) and (12) in column (3), in column (6), the following special condition shall be inserted, namely,- “Import is allowed for manufacture of Dyes Stuff only.”; (18) against S. No. 40, against entry (7) in column (3), in column (4), for the figure “7211.1990” the figure “72.20” shall be substituted; (19) against S. No. (46), in column (3), entry (16) and corresponding entry relating thereto in column (4) shall be omitted; (20) in S. No. 47, against item (2) in column (3), in column (5), for the figure “5” the figure “0” shall be substituted; (21) against S. No. (51), in column (3), entry (2) and corresponding entry relating thereto in column (4) shall be omitted;

Page 4

(22) against S. No. 53, (i) Under entry (ii) in column (3),- (a) item (31) and corresponding entry relating thereto in column (4) shall be omitted; (b) in item (75) after the word “agents” the words “ and preparation” shall be added; (ii) under sub-serial (iii) in column (3), entry (2) and corresponding entry relating thereto in column (4) shall be omitted; (23) against S. No. (54), in column (3), entries (16) and (17) and corresponding entries relating thereto in column (4) shall be omitted; (24) S. No. 66 and corresponding entries relating thereto in columns (2), (3), (4), (5) and (6) shall be omitted; (25) against S. No. (80), in column (3), entries (3) and (4) and corresponding entries relating thereto in column (4) shall be omitted; (26) against S. No. (81), in column (3), entry (1) and corresponding entries relating thereto in columns (4) and (5) shall be omitted; (27) against S. No. (82), in column (3), entry (5) and corresponding entry relating thereto in column (4) shall be omitted; (28) against S. No. (84), under heading (B) in column (3), against entry (1), in column (4), for the figure “8531.8019” the figure “8531.8000” shall be substituted; (29) against S. No. (85), in column (3), entry (5) and corresponding entry relating thereto in column (4) shall be omitted; (30) against S. No. 91, in column (3),- (i) against entry (2), in column (4), for the figure “28.17” the figure “2817.0000” shall be substituted; and (ii) against entry (3), in column (4), for the figure “28.19” the figure “2819.9010” shall be substituted; (31) against S. No. (94), in column (3), entries (1), (4), (6), (7), (8), (9), (10), (14), (17), (18), and (20) and corresponding entries relating thereto in column (4) shall be omitted; (32) against S. No. (95), in column (6), in entry (ii) for the words “deletion program” the words “progressive manufacturing plan volunteered by the manufacturer” shall be substituted;

Page 5

(33) against S. No. (97), in column (3), entry (8) and corresponding entry relating thereto in column (4) shall be omitted; (34) against S. No. 98, after entry (2) in column (3) and corresponding entries relating thereto in columns (4) and (5), the following new entry and corresponding entries relating thereto shall be added, namely,- “(3) Non Grain Oriented Electrical Steel 7225.1900 0% ad val”; Sheet (35) against S. No. 103, in column (3),- (i) against entry (2), in column (4), for the figure “8506.5000” the figure “8507.2090” shall be substituted; (ii) against entry (4), in column (4), for the figure “8506.5000” the figure “8529.9090” shall be substituted; (iii) against entry (8), in column (4), for the figure “8535.1000” the figure “8536.1000” shall be substituted; and (iv) against entry (9), in column (4), for the figure “8538.1000” the figure “8529.9090” shall be substituted; (36) against S. No. 104, against entry (1) in column (3), in column (4), for the figure “4008.2900” the figure “4008.2990” shall be substituted; (37) against S. No. (112), in column (3), entry (5) and corresponding entry relating thereto in column (4) shall be omitted; (38) against S. No. (113), in column (3), for entries (9), (10), (11), (12), (13), (14), (15), (16), (17), (18) and (19) and corresponding entries relating thereto in column (4) the following shall be substituted, namely,- “Scratch Labels: - (9) Silver Labels 3919.9090 (10) PLFW401 3919.9090 (11) PLNC1 3926.9099 (12) Gray Scratch off Panel 3919.9090 Pet Roll Laminates: - (13) Entreoise Lamination 3919.9090 (14) Polish Guard 3919.9090 Inks: - (15) Graphicard Gold 3215.1190 (16) Graphicard Dazzling Silver 3215.1190”; (39) against S. No. (114),- (i) against entry (1) in column (3), in column (4), for the figure “3824.9090” the figure “3824.9099” shall be substituted;

Page 6

(ii) in column (3), entries (2) and (5) and corresponding entries relating thereto in column (4) shall be omitted; (40) S. No. 115 and corresponding entries relating thereto in columns (2), (3), (4), (5) and (6) shall be omitted; (41) against S. No. (117), in column (3), entry (2) and corresponding entry relating thereto in column (4) shall be omitted; (42) against S. No. 119, in column (4), for the figure “8525.2090” the figure “8525.6090” shall be substituted; (43) S. No. 121 and corresponding entries relating thereto in columns (2), (3), (4), (5) and (6) shall be omitted; (44) against S. No. 123 in column (1), in column (3),- (i) against entry (1), in column (4), for the figure “2525.2000” the figure “2526.2000” shall be substituted; and (ii) against entry (3), in column (4), for the figure “2715.0000” the figure “2712.9090” shall be substituted; (45) S. No. 125 and corresponding entries relating thereto in columns (2), (3), (4), (5) and (6) shall be omitted; (46) against S. No. 126, in column (4), for the figures “8517.0000” and “8525.0000” the words “Respective Headings” shall be substituted; [C.No. 1(7) II & T-III/2007 - ] (MUSARRAT JABEEN) Additional Secretary

Which SROs does the title refer to?

  • SRO 565(I)/20065 June 2006Exemption from customs duty on import of raw materials, sub-components, components, sub-assemblies and assemblies, for manufacture of specified goods (Survey based).Exemptions and concessions

Related Customs SROs on amendments to earlier sros

All SROs on amendments to earlier sros

Report an error on this page